Issue with Calibration Addon

Issue with Calibration Addon

Postby aaronpawlak » 03 May 2018, 16:54

HI,

I followed all the steps for the calibration addon until the step Calibration Nozzle Height. When I press it the printer starts to move and doesn't stop even hiting the table and doing awful noise.During this i need to disconnect the printer to stop, so i cannot use the nozzle calibration. Can someone help me to check what am i doing wrong?

Please help.

I did not find the right solution from the internet.

References:
http://beeverycreative.com/forum/viewtopic.php?t=798
Creative video service

Thanks!
aaronpawlak
 
Posts: 10
Joined: 26 Dec 2017, 14:09

Return to 1.12.1 Addon Discussion

Who is online

Users browsing this forum: No registered users and 0 guests

cron